Power Line Carrier Communication
Input Filter Output Filter / TriState Switch TS SO DAC Buf AMP Application I/O Host System SSC P300 PL Network Interface Controller IC Power Line Analog Functions 1 SSC P300 Description Resource intensive Data Link functions and Physical Layer services of the protocol are provided by the SSC P300. Specific DLL services include transmission and reception of packets, byte-to-symbol conversion for transmit packets, symbol-to-byte conversion for received packets, transmit channel access (based on packet priority and EIA-600 access rules) and CRC generation and checking.
The Host Microcontroller interprets commands and data for the User Application and performs end to end protocol functions. Output signal amplification and filtering, input signal filtering, and node coupling to the power line is accomplished using external components. SSC P300 interface to the Host system is supported through a Serial Peripheral Interface (SPI) using five I/O lines. A hardware, active-low, Reset (RST*) signal is also supplied by the Host system.
Only $13.90 / page
A simple protocol is used to transfer commands and data between the host and SSC P300.
These commands and data include packets to be transmitted, received packets, status and configuration information. Analog data is transferred between the AC power line and the SSC P300 over the Signal In (SI) and Signal Out (SO) pins. In transmit mode, SSC “ chirps”from the SSC P300 SO pin are routed to the Output Amplifier, which is enabled by the SSC P300 Tristate (TS) signal. Once amplified, the output signal passes through a low-pass Output Filter, which removes harmonic energy (distortion) from the transmit signal, and on to the Tristate Switch.